|
|
Similar Products
|
Mfr.
Manchester Tank
Brass Flared Nut Cap, LP Propane Fitting...
|
$0.96
-
$3.30
|
|
Mfr.
Manchester Tank
Complete tank base, rod, bracket, wing nut for dual tank set up. Buy complete or only the pieces you need. Propane Tank Not Included...
|
$0.89
-
$38.47
|
|
Part#
06-0313 |
Mfr.
Marshall Products |
Mfr#
G-474
Type 1 ACME x 1"-20 male fitting...
|
|
|
Part#
06-0328 |
Mfr.
Marshall Products |
Mfr#
G-483
1"-20 female with gasket to protect and seal all fittings with 1"-20 male thread. Knurled finish eliminates need for tools to tighten securely...
|
|
|
Part#
06-0326 |
Mfr.
Marshall Products |
Mfr#
G-415P
POL x female POL x 1"-20 male tee. Install between tank valve and existing regulator or pigtail...
|
Item Not Available
|
|
Part#
06-0314 |
Mfr.
Marshall Products |
Mfr#
G-422
Type 1 ACME x Type 1 ACME x 1"-20 male tee. Install between tank valve and existing regulator or pigtail...
|
Item Not Available
|
|
Part#
06-0323 |
Mfr.
Marshall Products |
Mfr#
G-423P
POL x Type 1 ACME x male 1"-20 elbow. Install between tank valve and pigtail...
|
Item Not Available
|
|
Part#
06-0338 |
Mfr.
Marshall Products |
Mfr#
535-00
The Extend-A-Flow Kit consists of a brass adapter tee and hose which may be quickly and safely connected between the L.P. tank and regulator of a recreational vehicle...
|
|
|
Part#
06-0341 |
Mfr.
Marshall Products |
Mfr#
538-00
The Extend-A-Flow Plus Kit consists of a brass adapter elbow and hose which may be quickly and safely connected between the LP tank and regulator...
|
|
|
Part#
06-0317 |
Mfr.
Marshall Products |
Mfr#
G-426
Type 1 ACME x Type 1 ACME x 1"-20 male with female 1/4" inverted flare on the side...
|
Item Not Available
|
|
Mfr.
Marshall Products
A high pressure U.L & C.G.A. listed thermoplastic flexible pigtail. End fittings are excess flow P.O.L. x 1/4" inverted flare. The pigtails comply with...
|
$10.26
-
$11.29
|
|
Part#
06-0320 |
Mfr.
Marshall Products |
Mfr#
G-475P
Adapter fitting to use with a hose (not included) for barbecues, portable stoves, or any high pressure appliance. Male 1"-20 x soft nose full flow hand wheel POL...
|
|
|
Part#
06-0661 |
Mfr.
Marshall Products |
Mfr#
1005
POL adapter with 3/8" Flare threads on the other end...
|
|
|
Part#
06-0659 |
Mfr.
Marshall Products |
Mfr#
G1899P
The Retro-Q Cylinder Valve Adapter is designed to be installed permanently in the valve of your old cylinder. A special drive nut is constructed to break away...
|
Item Not Available
|
|
Part#
06-0306 |
Mfr.
Marshall Products |
Mfr#
G-480P
The 2nd Chance LP Grill Adapter allows small disposable cylinder to be connected to regulator of system fueled by refillable tank if you run out of gas...
|
Item Not Available
|
|
Part#
06-0399 |
Mfr.
Marshall Products |
Mfr#
ACC539
2-Stage Automatic Changeover Regulator, Cover, Replacement Inlet Fitting. Two stage automatic change-over regulator...
|
Item Not Available
|
|
Part#
06-0319 |
Mfr.
Marshall Products |
Mfr#
G-1654P
The soft nose POL fitting has convenient handwheel for tightening up to LP tank. The G-1654 features 1/4" MPT by Soft Nose Full Flow POL. The G-1653 features 1/4" MPT x Soft Nose Excess Flow POL...
|
|
|
Part#
06-0657 |
Mfr.
Marshall Products |
Mfr#
1000
Constructed with an "O" ring behind each inlet & a disk check seating into the "O" ring. For 1/4" inverted flare connections on inlet and 1/4" pipe outlet...
|
|
|
Part#
06-0311 |
Mfr.
Marshall Products |
Mfr#
G-412
Type 1 ACME x 1"-20 male. Connect to any refillable LP Vapor Tank to fuel two separate portable appliances. Male fittings have valves...
|
|
|
Part#
06-0656 |
Mfr.
Meeder Equipment |
Mfr#
J-400
Replacement 10% bleeder valve for tanks with separate 10% bleeder valve...
|
|
|
Mfr.
Mr. Heater
Eliminates tools and wrenches. Simply push to connect-pull to disconnect...
|
$34.05
-
$35.05
|
|
Part#
06-0315 |
Mfr.
Mr. Heater |
Mfr#
F276132
1"-20 male x soft nose POL male...
|
|
|
Part#
06-0345 |
Mfr.
Stromberg Carlson |
Mfr#
2020-JR
Wall mount tank rack for van or camper. Colonial white powder coat finish. Full width support...
|
|
|
Part#
06-0462 |
Mfr.
Suburban Manufacturing |
Mfr#
520790
Easy to install. Solid state pilot reignitor. Includes reignitor, electrode, power & ground wires, 2 strain reliefs, junction box, mounting hardware, template and full instructions...
|
|
Above is the price you will be charged if you purchase this item(s). We do not show this price on the advertised page because your price is below the manufacturer's suggested advertised price.
Products: 49 - 72 of 160
|
|
|
